SPECIALIST : Alat Selam - Alat Snorkeling - Kursus Dive Course - Service Alat Selam - Terra Tabung - Perahu Karet - Banana Boat - Rafting Boat - Mesin Kapal



Customer Service

TESTIMONI ??










Ruko Surya Inti Permata Blok E No.61-62, Jl Jemur Andayani No.50, Surabaya
(Komplek Ruko Bank BNI Jemur Andayani)



SENIN - JUMAT :
08.30 - 17.00

SABTU :
08.30 - 16.00

MINGGU :
LIBUR



0812-3323-1925
All Category
SEA WALKER
HELMET
KANO/KAYAK/
PADDLE BOARD
OUTBOARD MOTOR
BROCO WELDING
FOURTH ELEMENT
HALCYON
XDEEP
DIVERITE
TUSA
GULL
SHEARWATER
WEEFINE
XADVENTURER
GOPRO
BAUER COMPRESSOR
SUBLUE SEA SCOOTER
CETMA COMPOSITES
LEADERFINS
EPSEALON
IMERSION



q1  large  
Compressor Hookah-P Gasoline System
Kode : 12110
Deskripsi :

GARANSI 3 BULAN KERUSAKAN PABRIK
BUKAN KERUSAKAN PEMAKAIAN
(Belum termasuk ongkir pulang pergi). 
 
HOOKAH COMPRESSOR GASOLINE

Hookah Diving Compressor 

  •      Capacity 2 person.
  •      Working with oil
  •      All the spare part is ready in stock
  •      Two output air breathing (2 person)

Include / Termasuk : 

·    1x 2nd stage octopus + Black hose

·    1x Repair kit

Exclude / Tidak Termasuk:

·    Diving Mask

SAFETY CAUTIONS

Please read this operation manual carefully before installation and operation 

This series are high pressure air compressor. It compresses atmosphere air go to pressure 0.3/0.8Mpa, 45/110psi, after be purified and separated by the filter and separator.

It discharge clean air accords to GB18435-2001 breathing air standard. It is widely be used for breathing of diving and fire fighting; paintball PCP shooting and other high pressure filed industries by its reliability, durability and portability.

Products range 

·    DC 12V

·    AC 110V 220V

·    Gas engine driven 

·    Optional accessories : diving hose and musk 

·    Check the electric voltage in nameplate is same as your local electric supply

·    Check the lubricate oil has been put in before running

·    Increase rated pressure setting is forbidden

·    There is potential danger of pipe burst or connect fitting blow off under high pressure,  please avoid body too near compressor when it running

·    if there are no auto stop function, don't leave compressor until it reach rated pressure and shut down it by manual

TECHNICAL DATA 

SCU80P /  Gasoline Engine Driven Diving air compressor

·    Charging Rate: 250L/min; 8cfm

·    Suction pressure: atmosphere

·    Working pressure: 0.8MPa 8bar,  110psi

·    Media: air

·    No.of stage and cylinder: 1

·    Engine power:  5HP / HONDA

·    Cooling: air

·    Driven: belt driven

·    Shout downAutomatic stop by pressure switch

·    Pressure indicateGauge

·    Protection Safety valve in outlet

·    Filtrationwater separator and breathing filter

·    Lubricant: ISO grade 100# compressor oil

·    Dimension850 X 400 X 500mm

·    Weight50kg

·    NoiseLess than 70 dB(A)

·    Receiver tank: 10 liters stainless steel tank

·    Outlet: 2 ports, with outlet pressure regulator 

STRUCTURE  

Working process

Atmosphere air is sucked into cylinder of the compressor, and compressed to reach 0.3Mpa/0.8MPa 40/110 psi pressure, through regulator with water separator , then purified by filter. Discharge clean air for diving breathing.

Pump unit

The pump block unit is composed of crankcase, crankshaft, cylinder, piston, intake and discharge valves, connect rod , bearing etc. It is oil less belt driven type compressor.

Gauge & safety valve

The pressure gauge is installed in final stage of the compressor to display discharge pressure.

The safety valve is installed at the place of discharge to take the overpressure protection. If the discharge pressure is higher than preset value, the safety valve will open and release pressure.

Note: do not adjust the safety valve, otherwise it will result in serious damage

Pressure switch

The compressors are preset rated working pressure as per order . The compressor will stop automatically when pressure reach rated pressure. And re-start compressor when pressure is lower than minimum.

Note: don’t try to adjust it if not get authorized

Electric starter

Start gasoline / petrol engine

Drain valve

Open valve under receiver tank to drain moisture water in tank.

 

INSTALL AND OPERATION 

Installation

The compressor must be mounted on a firm, level base Where is with well-ventilated and rain-proof , non-hazardous locations

The environment temperature is d to be lower than 40 degree C. 

Check before running

Oil level check

Check the oil level which must be keep between max. and min. line.

Note: if the oil level is too high, air valves will carbonize, if it is too low , will result in insufficient lubrication and cylinder sticking

·    Check connect fitting and valve to make sure no leakage

·    Check rotary direction of motor, the right direction should be a cooling wind to the cylinder

·    install intake air filter on pump block

   Running

·    Connect air hose to discharge outlet port with fast plug in coupling

·    Open discharge check valve

·    Close drain valve under air tank

·    Start engine to run compressor

·    Compressor will download automatically when reach rated pressure ( presetting unload pressure is 0.8Mpa/ 8bar/ 110psi),  and load again when pressure drop down to minimum pressure ( presetting load pressure is 0.5Mpa/ 5bar/ 75psi)

·    Turn around regulator to make discharge pressure go through air hose to suitable for  mask breathe.

·    Shut off engine to stop compressor when finish work

MAINTENANCE

General maintenance interval

 

Every refill

5 h

25 h

30 h

50 h

100 h

1000 h

annually

Oil level check

 

 

 

 

 

Belt tension

 

 

 

 

 

 

Air intake filter

 

 

 

 

 

Safety valve check

 

 

 

 

 

 

 

Hose and fitting check

 

 

 

 

 

 

Check    

Lubricate oil

Oil level must be checked every 25 hours; oil must be d after 100 working hours or annually, and 50 working hours to change oil for the first time. DMC SYNTHETIC oil, MOBIL SPECIAL 20W50, MOBIL RARUS 827-829, ANDEROL 755 SYNTHETIC are recommended.

Warning: it is forbidden to mix different brand or ISO grade oil for lubricate

Check    

Air filter

blow air filter by compressed air to clean dust.

The air filter element must be changed every 2000 working hours or annually.

Filtration for breathing air (ACTIVE CARBON FILTER)

The outlet air purification depends on the activated carbon and molecular sieve, so filter elements must be d periodically, especially for breathe purpose. Follow are advice interval time.

Ambient temperature()

CapacityL× Number

Time for changehour

40

6×55

10

30

6×100

18

20

6×160

30

10

6×300

55

5

6×400

75

0

6×600

110

Note: Filter elements must be d at once if people feel particular smell.

Replacement: open the filter cover; the active carbon in bottle

 

TROUBLESHOOTING

Fault Reason

Over low P

Over high P

Over noise

Over heat

Not start

Air leak

Pressure switch damage

 

 

 

 

Motor capacitor damage

 

 

 

 

 

safety valve damage

 

 

 

drain valve damage

 

 

 

 

Discharge valve damage

 

 

 

Piston ring damage

 

 

 

 

protector shut off

 

 

 

 

 

foot damage

 

 

 

 

 

Solenoid valve damage

 

 

 

 

One way valve damage

 

 

 

 

DC/AC power too low

 

 

 

 

intake filter block

 

 

 

 

 

In/out valve damage

 

 

 

 

 

Note:

Rekomendasi dari pemerintah digunakan untuk kedalaman maksimal 5 meter

Harga
Rp 27.999.000,-

Jumlah :


 




Ada pertanyaan tentang produk?
SMS/CALL/WA: 081231923538

Email: surabayadiveshop@gmail.com