SPECIALIST : Alat Selam - Alat Snorkeling - Kursus Dive Course - Service Alat Selam - Terra Tabung - Perahu Karet - Banana Boat - Rafting Boat - Mesin Kapal



Product
FISH FINDER / GPS / HT
SEA WALKER HELMET
KANO/KAYAK/PADDLE BOARD
OUTBOARD MOTOR
UNDERWATER SCOOTER
USED GEAR
INFO WISATA

Testimonial

ariansyah
Terimakasih Surabaya dive shop, Barangnya berkualitas harga murah dibanding yg lain,proses cepat sampai tujuan dengan aman. Recomended SURABAYA DIVE SHOP. Jaya selalu.


d seafrog vacum 20191214125025  large  
Vacuum Pump System Housing Camera Sea Frogs
Kode : 8066
Deskripsi :
 
VPS-100 - VACUUM PUMP SYSTEM HOUSING CAMERA SEA FROGS
 
Compatible models of underwater camera housings :
  • Sony A6xxx series Salted Line 60M/195FT Underwater camera housing
  • Sony A7 II NG Series 40M/130FT Underwater camera housing
  • Sony A7 III 40M/130FT Underwater camera housing
  • Sony A7R III 40M/130FT Underwater camera housing
  • Sony A9 40M/130FT Underwater camera housing
  • Panasonic Lumix GH5 & GH5 S 40m/130ft Underwater Camera Housing
  • Olympus TG-3 & TG-4 60m/195ft SeaFrogs Underwater Camera Housing
  • Olympus TG-5 60m/195ft SeaFrogs Underwater Camera Housing
  • Fujifilm X-T2 40M/130FT Underwater camera housing (units that are sold from 1st of May 2019)
  • Canon G1X III 40m/130ft SeaFrogs Underwater Camera Housing
Included :
  • Electronic valve
  • Pump
  • Screwdriver (for battery rpcment)
The vacuum pump system is used for checking the watertightness of underwater camera housing before submerging.
  • Install the camera inside underwater camera housing in dry and low humidity level place.
  • 15-30 minutes before your dive remove the lid from back plate to access vacuum pump system opening and make sure the O-ring stays in place.
  • Attach vacuum pump system to the opening by screwing it clockwise.
  • Unscrew the lid of electronic valve and press the button to turn on LED inside the valve.
  • Attach the rubber part of a pump to valve and start pumping air out.
  • Red LED starts blinking, indicating ambient atmospheric pressure. The hand pump is fitted to the threaded valve body and the air is pumped out of a unit until the red LED changes to green LED and add couple more strokes to make sure the sufficient underpressure.
  • The additional stroke or two ensures that the valve is not on the edge of threshold. The pump is then removed, and the protective cap d to ensure airtightness.
  • Observe the green LED blinking for 15 minutes to make sure there is no air leakage. Unscrew the lid of a valve to access the button and press it for a few seconds to release the pressure from inside and turn the valve LED off.
  • Remove the valve from back plate and place vacuum opening lid to its original place, make sure the O-ring is still there
  • LINK : meikon.com.hk/products/vacuum-pump-system-vps-100 
 
Harga
Rp 1.865.000,-

Jumlah :


 




Ada pertanyaan tentang produk?
SMS/CALL/WA: 081231923538

Email: surabayadiveshop@gmail.com