SPECIALIST : Alat Selam - Alat Snorkeling - Kursus Dive Course - Service Alat Selam - Terra Tabung - Perahu Karet - Banana Boat - Rafting Boat - Mesin Kapal



Customer Service

TESTIMONI ??










Ruko Surya Inti Permata Blok E No.61-62, Jl Jemur Andayani No.50, Surabaya
(Komplek Ruko Bank BNI Jemur Andayani)



SENIN - JUMAT :
08.30 - 17.00

SABTU :
08.30 - 16.00

MINGGU :
LIBUR



0812-3323-1925
All Category
SEA WALKER
HELMET
KANO/KAYAK/
PADDLE BOARD
OUTBOARD MOTOR
BROCO WELDING
FOURTH ELEMENT
HALCYON
XDEEP
DIVERITE
TUSA
GULL
SHEARWATER
WEEFINE
XADVENTURER
GOPRO
BAUER COMPRESSOR
SUBLUE SEA SCOOTER
CETMA COMPOSITES
LEADERFINS
EPSEALON
IMERSION



w1  large  
Compressor Hookah-E Accu System (Oil Free)
Kode : 121010
Deskripsi :
 
GARANSI 3 BULAN KERUSAKAN PABRIK
BUKAN KERUSAKAN PEMAKAIAN
(Belum termasuk ongkir pulang pergi). 
 
HOOKAH DIVING COMPRESSOR ACCU SYSTEM
  •      Use Accu 12v 100ah = 2 hours / 2 person.
  •      Working without using any oil
  •      All the spare part is ready in stock 
  •      Two output air breathing (2 person)

Include / Termasuk: 

·    1x  2nd stage octopus + Black hose

·    1x Repair kit

Exclude / Tidak Termasuk:

·    Diving Mask

·    Accu 12v 100ah  

SAFETY CAUTIONS  

Please read this operation manual carefully before installation and operation

This series are high pressure air compressor. It compresses atmosphere air go to pressure 0.3/0.8Mpa, 45/110psi, after be purified and separated by the filter and separator.

It discharge clean air accords to GB18435-2001 breathing air standard. It is widely be used for breathing of diving and fire fighting; paintball PCP shooting and other high pressure filed industries by its reliability, durability and portability.

Products range 

·    DC 12V

·    AC 110V 220V

·    Gas engine driven

·    Optional accessories : diving hose and musk

·    Check the electric voltage in nameplate is same as your local electric supply

·    Check the lubricate oil has been put in before running

·    Increase rated pressure setting is forbidden

·    There is potential danger of pipe burst or connect fitting blow off under high pressure,  please avoid body too near compressor when it running

·    if there are no auto stop function, don't leave compressor until it reach rated pressure and shut down it by manual

TECHNICAL DATA  

SCU80 /LM80/ DC 12V diving air compressor

·    Charging Rate: 60-100L/min; 2-3cfm

·    Suction pressure: atmosphere

·    Working pressure: 0.8MPa 8bar,  110psi

·    Media: air

·    No.of stage and cylinder: 1

·    DC power:  550W/12V

·    Cooling: air

·    Driven: direct driven with DC motor

·    Shout downAutomatic stop by pressure switch

·    Pressure indicateGauge

·    Protection Safety valve in outlet

·    Filtrationwater separator and breathing filter

·    Lubricant: oil free, no lube oil

·    Dimension500 X 450 X 450mm

·    Weight25kg

·    NoiseLess than 45 dB(A)

·    Receiver tank: 10 liters stainless steel

·    Outlet : 2 ports

STRUCTURE 

Working process

Atmosphere air is sucked into cylinder of the compressor, and compressed to reach 0.3Mpa/0.8MPa 40/110 psi pressure, through regulator with water separator , then purified by filter. Discharge clean air for diving breathing.

Pump unit

The pump block unit is composed of crankcase, crankshaft, cylinder, piston, intake and discharge valves, connect rod , bearing etc. 

It is oil-free, non lubrication, direct driven type compressor.

    Part number

  Part name

quantity

001

Pump body

1

002

Connect rod

2

003

Eccentric wheel bearing

2

004

Eccentric wheel kit

2

005

Cooling fan

2

006

Cooling fan cover

2

007

screw

2

008

Piston bowl ring

2

009

Press plate

2

010

screw

2

011

Cylinder seal

2

012

cylinder

2

013

Valve plate

2

014

Cylinder cover gasket

2

015

Discharge valve plate

2

016

screw

2

017

Limited position kit

2

018

Connect hose

2

019

Cylinder cover

2

020

screw

12

021

Intake valve plate

2

Maintain schedule

NO. 008 009 010 011 012 013 014 015 021 are consumable parts, regular it every 1year or 2000 hours. Time will be shorter if use compressor near the sea.

Gauge & safety valve

The pressure gauge is installed in final stage of the compressor to display discharge pressure.

The safety valve is installed at the place of discharge to take the overpressure protection. If the discharge pressure is higher than preset value, the safety valve will open and release pressure.

Note: do not adjust the safety valve, otherwise it will result in serious damage

Pressure switch

The compressors are preset rated working pressure as per order . The compressor will stop automatically when pressure reach rated pressure. And re-start compressor when pressure is lower than minimum.

Note: don’t try to adjust it if not get authorized

·    Electric starter

·    Press ON/OFF red button on pressure switch to start compressor.

·    Drain valve

·    Open valve under receiver tank to drain moisture water in tank.

INSTALL AND OPERATION 

Installation

The compressor must be mounted on a firm, level base Where is with well-ventilated and rain-proof , non-hazardous locations. The environment temperature is d to be lower than 40 degree C.

Check before running

Pressure switch check

·    pressure switch must be in position “ OFF” (STOP)

·    Intake air filter check

·    install intake air filter on pump block

Running

·    Connect electric cable to DC power supply (12V ONLY) DC battery: 12V ;    Power connection : red color wire/clamp to (positive pole) / black color wire/clamp to (negative pole

·    Connect air hose to discharge outlet port with fast plug in coupling

·    Open discharge check valve

·    Close drain valve under air tank

·    Press ON bottom in pressure switch to start compressor

·    Compressor will download automatically when reach rated pressure ( presetting unload pressure is 0.8Mpa/ 8bar/ 110psi), and load again when pressure drop down to minimum pressure ( presetting load pressure is 0.5Mpa/ 5bar/ 75psi)

·    Turn around regulator to make discharge pressure go through air hose to suitable for  mask breathe.

·    Press OFF bottom in pressure switch to stop compressor when finish work

   Note: Compressor is oil-free type, don't need any lubricate oil to take in

 

MAINTENANCE  

Intake filter element (No.022) and part NO. 008 009 010 011 012 013 014 015 021 are consumable parts,

regular it every 1year or 2000 hours. Time will be shorter if use compressor near the sea.

 

 

 

 

 

1000 h

 

Annually or 2000hrs

Intake air filter element

 

   

Piston bowl ring

 

   

Press plate

 

   

screw

 

   

Cylinder seal

 

   

cylinder

 

   

Valve plate

 

   

Cylinder cover gasket

 

   

Discharge valve plate

 

   

Intake valve plate

 

   

Check    

5.1 lubricate oil

Oil free type, don't need lube oil

5.2 air filter

blow air filter by compressed air to clean dust.

The air filter element must be changed every 2000 working hours or annually. 

5.3 Filtration for breathing air (ACTIVE CARBON FILTER)

The outlet air purification depends on the activated carbon and molecular sieve, so filter elements must be d periodically, especially for breathe purpose. Follow are advice interval time.

Ambient temperature()

CapacityL× Number

Time for changehour

40

6×55

10

30

6×100

18

20

6×160

30

10

6×300

55

5

6×400

75

0

6×600

110

Note: Filter elements must be d at once if people feel particular smell.

Replacement: open the filter cover; the active carbon in bottle

 

TROUBLESHOOTING

Fault Reason

Over low P

Over high P

Over noise

Over heat

Not start

Air leak

Pressure switch damage

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Motor capacitor damage

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

safety valve damage

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

drain valve damage

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Discharge valve damage

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Piston ring damage

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

protector shut off

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

foot damage

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Solenoid valve damage

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

One way valve damage

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

DC/AC power too low

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

intake filter block

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

In/out valve damage

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Note:

Rekomendasi dari pemerintah digunakan untuk kedalaman maksimal 5 meter

Harga
Rp 19.500.000,-

Jumlah :


 




Ada pertanyaan tentang produk?
SMS/CALL/WA: 081231923538

Email: surabayadiveshop@gmail.com